BMS
Jump to navigation
Jump to search
We are using the Tumanako EVD5 BMS
Saker specific BMS info:
Software
Use the following commands to get the BMS master up and running: ...
Hardware
The following pinout for the rs485 network does not appear to work. We believe the master is getting through to the slaves, in that they are responding, however there doesn't seem to be valid data returning to the terminal. Either that or the terminal is not receiving it correctly.
This data was derived from first principles on two separate occasions, ending in the same design. Either there is a subtle double negative, incorrect data supplied, or the port is not set up as necessary. A further test with oscilloscope is required.
RS485 pinout
Master | Slaves | |
---|---|---|
Signal | JRMX | EVD5 |
TX-1 | 1 | 2 |
TX+1 | 2 | 3 |
RX-1 | 4 | 5 |
RX+1 | 3 | 4 |
GND | 5 | 1 |
5V | - | 6 |
RS485 bias termination
This page has a good rs485 2/4wire and termination description