Difference between revisions of "EVI200 Info"
(Imported from TWiki by twiki2mediawiki.py) |
(Imported from TWiki by twiki2mediawiki.py) |
(No difference)
|
Revision as of 00:14, 21 July 2009
This page relates to how best hook up a surplus SKiiP module to an EV, using a STM32F103VBH6.
Q.1 How much of the existing packaging that came with the SKiiP should be reused?
- Case
- High current stuff (caps, bus bar etc.)
- 70pin vehicle loom adaptor (AMP/Tyco 1-962-526-1) AMP site
- Interface board (aux power supplies, drivers, buffers etc.)
- DSP board (Tricore DSP)
A.1 (Ed) No objections with case + high current stuff. The DSP is toast meaning the interface board will then require massive rework. The loom connector is technically good IMO, but looks like it will be a pain for EV enthusiasts to source. At the moment the plug gets a tick, the board gets a cross. For the existing users the connector can be salvaged to minimise loom rework. One new board to be designed/built to take SKiip or SKAI, ST32 and AMP plug, with ample headers and screw holes for future add ons/modifications.
I'll try to add datasheets collected thus far
-- Main.EdCheeseman - 20 Jul 2009
- File:1-962526-1 70pin automotive plug.pdf: 1-962526-1_70pin_automotive_plug.pdf